Outer Nozzle Replacement; Replacing The Pilot Burner Nozzle - Salvis VisionPRO Typ 810 Serie Betriebsanleitung

en
Nozzle type Nozzle type Nozzle type
Gas type Gas type Gas type
PL - Category: II
Natural gas E
Primary pressure 20 mbar
(PL)
Liquid gas 3B/P
Primary pressure 29/37 mbar
(PL)
7.2

Outer nozzle replacement

7.3

Replacing the pilot burner nozzle

Pilot burner
nozzle
Screw connection
for gas line
34 / 68
Outer nozzle
Refer to page 34, chap­
ter 7.2
2E 3B/P
ø 1,65 mm
ø 1,10 mm
Threaded pin
Connector
Outer nozzle
Pilot burner
Spark plug
Pilot burner nozzle
For pilot burner nozzle repla­
cement, refer to page 34,
chapter 7.3
Pilot burner nozzle with two
bores of ø 0.25 mm each
ø 0,20 mm
. Loosen the threaded pin until the connector
can be withdrawn.
. Withdraw the connector.
. Replace the outer nozzle, refer to the data
stated in the table on page 32, chapter 7.1
. Insert the connector down to the limit stop
and secure it by means of the threaded pin.
. Check all gas-bearing components for the
leak tightness.
. Unscrew the spark plug to protect it against
any damage during the conversion process.
. Screw out the gas line to the pilot burner.
D Caution, the pilot burner nozzle may fall out!
. Replace the pilot burner nozzle, refer to the
data stated in the table on page 32, chap­
ter 7.1
Risk of breakage! The spark plug may
be damaged by excessive fastening. Therefore,
fasten the spark plug only lightly!
. Check all gas-bearing components for the
leak tightness.