Correct Positioning Of The Piece In The Clamp (Fig. 13); Cutting Capacity - Femi N215 XL Gebrauchsanleitungen

• fi t the protective casing.
At this point, activate button A (Fig. 4) with small impulses
so that the blade positions itself correctly on the pulleys.
4.5 USING THE VICE (Fig. 13)
The chuck of the saw is of the quick sliding type so that
the slider easily and rapidly approaches the pieces to be
locked.
To lock the piece to be cut in the chuck:
• place yourself in front of the machine;
• release the lever A towards the piece to be cut by
unlocking vice part B;
• position the slider at a few millimetres from the piece to
be cut;
• move the A towards the piece and lock it;
• turn lever C clockwise so as to defi nitely lock the piece
between the jaws.
If more pieces of the same bar are to be cut, you only need
to unlock and then re-lock the chuck by means of lever C.
If you need, instead, to change the bar, turn the lever C
counterclockwise to unlock the chuck and then pull lever
A towards you so that the slider moves away from the
piece.
4.6 CORRECT POSITIONING OF THE PIECE IN
THE CLAMP (Fig. 13)
The pieces to be cut should be fi tted directly between the
jaws D without adding other objects.
WARNING: Never hold the pieces to be cut in
your hand.
When the pieces to be cut are profi led sections, fl at pieces
or special shapes, refer to the examples shown in the
fi gures.
If the thickness of the profi led section is to be very thin,
an outline should be fi tted which copies the profi le inside
the profi led section itself to stop it being crushed between
the jaws.
4.7

CUTTING CAPACITY

The table below specifi es the cutting capacity at 90, 45 and
60 degrees which may be obtained in normal conditions of
use described in this manual and without placing any other
object between the jaws of the clamp.
14
Angle
Section
90 gradi
45 gradi
60 gradi
4.8 CUTTING TABLE
UNIVERSAL VERSION
INDUCTION VERSION 1 SPEED
INDUCTION VERSION 2 SPEED
Cutting capacity
(mm)
175
175 x 175
190 x 135
110
110 x 110
150 x 110
75
75 x 75
100 x 70