Correct Positioning Of The Piece In The Clamp; Accessories; Regular Maintenance - Femi 784 XL Gebrauchsanleitung Und Wartung

SECTION ANGLE
0°
45°
4.5 CORRECT POSITIONING OF THE PIECE IN THE
CLAMP
The pieces to be cut should be fi tted directly between the
jaws without adding other objects.
ATTENTION: Never hold the pieces to be cut in
your hand.
When the pieces to be cut are profi led sections, fl at pieces
or special shapes, refer to the examples shown in the
fi gures.
If the thickness of the profi led section is to be very thin,
an outline should be fi tted which copies the profi le inside
the profi led section itself to stop it being crushed between
the jaws.
4.6 CUTTING TABLE
5

ACCESSORIES

5.1 CHOISE OF BLADE
Your sawing machine is equipped with a bi-metal blade
measuring 1440x13x0.65 mm, for use in the majority of
cuts possible with this machine.
For special requirements (see cutting table point 4.6), for
CUTTING CAPACITY
example, for cutting large solid sections or profi led sections
(mm)
or corner pieces of small thickness, there are also blades
120
avail-able with 6, 14 or 18 teeth per inch.
MATERIAL: ...........M42 (acciaio per molle + acciaio HSS)
EXTENSION : .....................................................mm 1440
119x119
HEIGHT: .................................................................mm 13
THICKNESS: .......................................................mm 0,65
120x115
TOOTHING: .................................................standard 8/12
.................................................................optional 6-14-18
85
80x80
6
85x70
6.1
The operations of ordinary maintenance, which may also
be performed by non-specialist personnel, are all described
in the previous sections and here below.
1. Before performing any maintenance operation,
2. During maintenance operations, always wear personal
3. Remove the processing residues from the cutting
4. If you do not intend to use the sawing machine for a
6.2
Should it be necessary to call qualified personnel for
operations of extraordinary maintenance, or in the case
of repairs, under guarantee or at a later date, you should
always contact an authorized service centre or the factory
directly , if there is no service centre in your area.
6.3
NFORMATION FOR USERS
In accordance with art. 13 of Legislative Decree
25th July 2005, no. 151 "Implementation of
Directives 2002/95/EEC, 2002/96/EEC and
2003/108/EEC, relative to reducing the use of hazardous
substances in electrical and electronic appliances and the
disposal of waste", please take note of the following:
•
•
MAINTENANCE

REGULAR MAINTENANCE

disconnect the machine electric plug from the wall
outlet.
protection (safety goggles and gloves).
area and the blade guides whenever necessary.
You are advised to use a suction device or a brush.
ATTENTION: Do not use jets of compressed
air.
long time, clean it and put it in a dry place if possible.
In these cases it is advisable to slacken off the blade
so that it is not kept tight for no reason.
ASSISTENCE
DISPOSAL OF THE MACHINE AND PACKAGING
The crossed out wheelie bin symbol found on the
appliance or on the packaging, indicates that the product
must be disposed of separately from ordinary household
waste when it reaches the end of its working life.
The user must consign the unwanted appliance to
an authorized differentiated waste disposal centre for
electrical and electronic goods, or alternatively, hand
it over to the relative dealer on purchasing a new
appliance of the same type on the basis of a one to
one ratio.
11