Stryker 1188HD Benutzerhandbuch Seite 20

Wiring Diagram 3: Camera, Flat-Panel Monitor and CRT Monitor
Note If you are using any device with unterminated analog video
inputs, you must connect a cable from the VIDEO OUT of that
device to the VIDEO IN on the monitor.
Note An additional monitor may be connected using an open camera
output.
Note The camera console is shipped from the factory in NTSC video
format. If necessary, the video format can be changed to PAL by
using the "Options" submenu in the configuration menu. See the
"Using the Configuration Menu" section of this manual.
1. Power on the monitor.
2. Power on the camera.
Note A color bar pattern will appear on the monitor when the camera
head is not connected to the camera console. Follow the
instructions in the "Setting Up the Camera Head" section of this
manual to connect the camera head to the console.
EN-16