Setting Up The Camera Head; Setting Up The Coupler - Stryker 1188HD Benutzerhandbuch

Setting Up the Camera Head

1. Connect the camera head to the console.
• Unscrew the soaking cap from the cable connector if necessary.
• Align the blue arrow on the cable connector with the blue arrow on
the camera-connector port on the front console panel (see Figure 4).
• Push in the connector until it locks in place.
Figure 4: Connecting the camera head to the console
Note To unplug the camera from the control unit, grasp the knobbed
portion of the connector and pull straight out.
Caution Do not severely bend the camera cable or damage may result.

Setting Up the Coupler

1. Attach the coupler to the camera head.
• Grasping the rear adapter, screw the coupler onto the camera head
(clockwise) until it forms a tight seal (see Figure 5).
Figure 5: Attaching a coupler to the camera head
EN-17