Extended Operating Modes; Using The Help Function; Display Settings; Fig. 6.10: Settings Of The Button File/Print - Hameg HMS 3000 Handbuch

change the destination by opening the respective menu if you
press the softkey next to STORAGE). You can now save a Screens-
hot if you press the softkey next to SAVE using the predefined
name written in the menu below FILE NAME. You may name the
destination memory with up to 7 characters; in order to do this
select the menu item FILE NAME and define the name by using
the knob and the CURSOR SELECT key (in this example PRINT).
After the softkey next to ACCEPT was pressed the oscilloscope
will have stored the name and return to the settings menu. Here
you can now store the actual screen display by pressing the
SAVE softkey. Alternatively, you can return to a lower menu level
(by pressing the lowest Menu OFF key) and select the menu item
key FILE/PRINT. In the following menu press the soft menu key
next to SCREENSHOTS: this will assign the function screenshot
to the key FILE/PRINT with the settings chosen. This enables
you to store a bitmap file on your USB stick by just pressing
FILE/PRINT at any time and in any menu.

7 Extended operating modes

7.1

Using the help function

The integrated help function can be activated by pressing the
key HELP in the GENERAL area of the control panel. A window
will open and the text inside is dynamically updated depending
on the key (including softmenu key's) you are pushing or the
knob you are turning. If you do not need the help anymore, you
can switch off the help window by pushing the "HELP" key.
7.2

Display settings

By pushing the key DISPLAY the display settings menu will be
called; here several choices are offered:
– TRACE: EAdjustment of the trace intensity (0 ... 100 %) of
the displayed spectrum.
– BACKLIGHT: Adjustment of the backlight intensity (0...100 %).
– GRID: Adjustment of the raster intensity (0 ... 100 %). The
soft menu item GRID SETUP allows to select a cross, raster
lines or no raster with the respective soft menu keys. Also
the raster designations (SCALE) can be switched on or off.
The soft menu key LED INTENS changes the LED intensity
from dark to light, this is effective for all backlighted keys
and all other display LED's on the front panel.
TRANSPARENCY: Adjustment of the transparency (0 ...
–
100 %) of the raster inscriptions.
If a soft menu item is activated, its background will be blue.
The setting of the parameters is performed according to
chapter 4.
E x t e n d e d o p e r a t i n g m o d e s

Fig. 6.10: Settings of the button FILE/PRINT

Fig. 7.1: Display settings menu (DISPLAY)

7.3 Selection of the standard instrument
settings (PRESET)
By pushing the key PRESET the spectrum analyzer will resume
its preset standard settings. This allows to generate a new con-
figuration, starting out from defined parameters, no parameter
from a former setting will be active any more.
Center frequency: 1.5 GHz (HMS3000/3010)
500 MHz (HMS1000/1010)
Span: 3 GHz (HMS3000/3010)
1 GHz (HMS1000/1010)
7.4 EMC Precompliance software
To perform EMC measurements, a free of charge software is
necessary. It is available from www.hameg.com. For further
information to the HAMEG EMC software, please refer to the
software built-in help-sytem.
49
Subject to change without notice