Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
I m p o r t a n t h i n t s
The operator is requested to carefully reading the
following instructions and those of the mainframe
HM8001-2, to avoid any
operating errors and mi-
stakes and in order to beco-
me acquaint with the module.
After unpacking the module, check for any me-
chanical damage or loose parts inside. Should
there be any transportation damage, inform the
supplier immediately and do not put the module
into operation. This plug-in module is primarily
intended for use in conjunction with the Mainfra-
me HM8001-2. When incorporating it into other
systems, the module should only be operated with
the specified supply voltages.
Safety
This instrument has been designed and tested in
accor dance with IEC Publication 1010-1, Safety
require ments for electrical equipment for measu-
rement, control, and laboratory use. It corres-
ponds as well to the the CENELEC regulations EN
61010-1. All case and chassis parts are connected
to the safety earth conductor. Corresponding to
Safety Class 1 regulations (three-conductor AC
power cable). Without an isolating transformer,
the instrument's power cable must be plugged into
an approved three-contact electrical outlet, which
meets International Electrotechnical Commission
(IEC) safety standards.
Warning!
Any interruption of the protective conductor
inside or outside the instrument or discon-
nection of the protective earth terminal is
likely to render the instrument dangerous.
Intentional interruption is prohibited.
18
Subject to change without notice
Downloaded from
www.Manualslib.com
Important hints
FUSE
ON/OFF
VOLTAGE
manuals search engine
The istrument must be disconnected and secured
against unintentional operation if there is any
suggestion that safe operation is not possible.
This may occur:
–
if the instrument shows visible damage,
–
if the instrument has loose parts.
–
if the instrument does not function,
–
after long storage under unfavourable
circumstances (e.g. outdoors or in moist
environments),
–
after excessive transportation stress (e.g. in
poor packaging).
When removing or replacing the metal case, the
instrument must be completely disconnected
TRIPLE POWER SUPPLY HM 8040-3
from the mains supply. If any measurement or
FUSE
ON/OFF
OUTPUT
HAMEG
calibration procedures are necessary on the
PUSH LONG
CURRENT
VOLTAGE
CURRENT
opened-up instrument, these must only be carried
out by qualified personnel acquainted with the
danger involved.
Symbols marked on equipment:
Operating conditions
The ambient temperature range during operation
should be between +5 °C and +40 °C and should
not exceed –20 °C or +70 °C during transport or
storage. The operational position is optional, how-
ever, the ventilation holes on the HM8001-2 and
on the plug-in modules must not be obstructed.
Warranty and Repair
Our instruments are subject to strict quality con-
trols. Prior to leaving the manufacturing site, each
instrument undergoes a 10-hour burn-in test. This
is followed by extensive functional quality testing
to examine all operating modes and to guarantee
compliance with the specified technical data. The
testing is performed with testing equipment that
is calibrated to national standards. The statutory
warranty provisions shall be governed by the laws
of the country in which the product was purchased.
ATTENTION refer to manual.
DANGER High voltage.
Protective ground (earth) terminal.
Werbung
Kapitel
Inhaltsverzeichnis
