E) Function "Alarm; F) Function "Upgrade - Renkforce 1505092 Bedienungsanleitung

e) Function "Alarm"

With this function, you can switch the alarm sound on or off. The alarm sound will be tripped when you have chosen
recording at motion detection (see chapter 16. a) and the screen/DVR has recognised a motion in the area recorded
by the radio camera.
Proceed as follows:
• Briefly push the "Menu" button (5) on the screen/DVR or the "MENU" button on the IR remote control. Then the
main menu is displayed.
• Use the " " or the " " button to select the submenu "System Setting" and then briefly push the "
• Use the " " or the " " button to select the function "Alarm" and then briefly push the "
• Use the " " or the " " button to switch between "YES" (alarm sound on) and "NO" (alarm sound off).
• Confirm the selection by pushing the "
• The screen/DVR then switches back to the previous menu.
• To switch one menu level back or to leave the OSD menu, briefly push the "Menu" button (5) on the screen/DVR or
the "MENU" button on the IR remote control (you may need to push it several times).

f) Function "Upgrade"

This function is used to perform a firmware upgrade by the manufacturer.
If the screen/DVR has a firmware upgrade available, this is provided under www.conrad.com on the corresponding
product page.
Proceed as follows:
• Use a new, empty memory card. Copy the new firmware into the root directory of the memory card. Insert the
memory card into the screen/DVR.
• Briefly push the "Menu" button (5) on the screen/DVR or the "MENU" button on the IR remote control. Then the
main menu is displayed.
• Use the " " or the " " button to select the submenu "System Setting" and then briefly push the "
• Use the " " or the " " button to select the function "Upgrade" and then briefly push the "
• Use the " " or the " " button to switch between "YES" (perform upgrade) and "NO" (cancel).
• Confirm the selection by pushing the "
• If "YES" has been chosen, the screen/DVR will start the firmware upgrade.
Do not switch off the screen/DVR or disconnect it from the operating voltage. This would damage the
screen/DVR! Loss of guarantee/warranty!
Do not push any button on the screen/DVR during the upgrade.
• After completing the upgrade, the screen/DVR will restart.
" button briefly.
" button briefly.
" button.
" button.
" button.
" button.
61