C) Function "Motion Detection - Renkforce 1505092 Bedienungsanleitung

c) Function "Motion detection"

In this function, the sensitivity of motion detection can be set in 3 hours. The screen/DVR can start the recording when
a change results in the monitoring area, e.g. when a person or car moves in the recording area of the camera lens.
The motion detection is based on the detection of differences in the video image. If the radio camera is, e.g., pointed
at trees or bushes, the movement of foliage or branches may trigger a recording.
If error recordings happen often in spite of a lower sensitivity, the camera should be aligned differently or
installed at a different site.
Proceed as follows:
• Briefly push the "Menu" button (5) on the screen/DVR or the "MENU" button on the IR remote control. Then the
main menu is displayed.
• Use the " " or the " " button to select the submenu "Record Setting" and then briefly push the "
• Use the " " or the " " button to select the function "Motion Detection" and then briefly push the "
• Briefly push the button "
• Use the " " or the "
• Set the desired sensitivity with the " " or the " " button.
"Low" = Low sensitivity
"Mid" = Medium sensitivity
"High" = High sensitivity
• Confirm the setting by pushing the "
• The screen/DVR then switches back to the previous menu. If you want to set the sensitivity for another channel,
proceed as described above.
• To switch one menu level back or to leave the OSD menu, briefly push the "Menu" button (5) on the screen/DVR or
the "MENU" button on the IR remote control (you may need to push it several times).
66
" again in the following menu.
" buttons to select one of the four channels ("cam 1", "cam 2", "cam 3" or "cam 4").
" button briefly.
" button.
" button.