Inserting Batteries In The Ir Remote Control, Battery Replacement - Renkforce 1505092 Bedienungsanleitung

c) Inserting batteries in the IR remote control, battery replacement
• If there is a thin protective film on the IR remote control, pull it off now.
• The IR remote control needs a battery type "CR2025".
At initial commissioning, the battery is already in the battery compartment of the IR remote control. A plastic
strip protects the battery from premature discharge.
Pull out the plastic strip to make the IR remote control operational.
• A battery change is required if the range of the IR remote control drops or the screen/DVR no longer reacts to the
IR remote control at all.
• To perform the battery change, the small locking clip at the battery compartment must be unlatched, e.g. with a flat
screwdriver, upon which the battery holder and battery can be pulled out.
• Replace the empty battery with a new one of type "CR2025". Always observe the correct polarity (plus/+ and
minus/-) when inserting the battery. The plus pole of the battery is marked with the icon "+" and must point towards
the bottom of the IR remote control.
• Push the battery holder back into the IR remote control. Observe correct orientation. Do not apply any force!
• Dispose of the flat, used-up battery in an environmentally compatible manner; see chapter "Disposal".
52