D) Function "Camera Brightness; E) Function "Anti-Flicker - Renkforce 1505092 Bedienungsanleitung

d) Function "Camera brightness"

In this function, the screen brightness for each radio camera can be set separately. This way, brightness differences
of the different radio cameras/channels can be adjusted to each other.
Proceed as follows:
• Briefly push the "Menu" button (5) on the screen/DVR or the "MENU" button on the IR remote control. Then the
main menu is displayed.
• Use the " " or " " button to select the submenu "Camera setting" and then briefly push the "
• Use the " " or the " " button to select the function "Camera Brightness" and then briefly push the "
• Use the " " or the "
• Set the desired image brightness with the " " or the " " button. The higher the value, the higher the image bright-
ness of the respective channel in the display of the screen/DVR.
• Confirm the setting by pushing the "
• The screen/DVR then switches back to the previous menu. If you want to set the image brightness for another
channel, proceed as described above.
• To switch one menu level back or to leave the OSD menu, briefly push the "Menu" button (5) on the screen/DVR or
the "MENU" button on the IR remote control (you may need to push it several times).

e) Function "Anti-flicker"

If the radio cameras are in locations where light from fluorescent/energy saving lamps is visible in the picture, there
may be undesired flickering effects. Therefore, you can use this menu to set the frequency of the mains voltage to
avoid such effects.
Proceed as follows:
• Briefly push the "Menu" button (5) on the screen/DVR or the "MENU" button on the IR remote control. Then the
main menu is displayed.
• Use the " " or " " button to select the submenu "Camera setting" and then briefly push the "
• Use the " " or the " " button to select the function "Anti-flicker" and then briefly push the "
• Use the " " or the " " button to switch between "50 Hz" and "60 Hz" (frequency of the mains voltage at the site of
operation of the radio cameras; this is the frequency at which fluorescent or energy-saving lamps "flicker").
• Confirm the setting by pushing the "
• The screen/DVR then switches back to the previous menu.
• To switch one menu level back or to leave the OSD menu, briefly push the "Menu" button (5) on the screen/DVR or
the "MENU" button on the IR remote control (you may need to push it several times).
58
" buttons to select one of the four channels ("cam 1", "cam 2", "cam 3" or "cam 4").
" button briefly.
" button briefly.
" button.
" button.
" button.
" button.