Alarm System Deactivation (No Alarm Triggered); Alarm System Deactivation (Alarm Triggered); Overview Of The Optical And Acoustic Signals - Renkforce 752181 Bedienungsanleitung

12. Alarm System Deactivation (No Alarm Triggered)

If you enter your apartment or house, proceed as follows:
Press the key switch until the internal signalling device emits two beeps.
• The "ZONE STATUS" LED goes out.
• The alarm system is deactivated.

12.1 Alarm System Deactivation (Alarm Triggered)

Press the key switch until the internal signalling device emits two beeps.
• The LED "ZONE STATUS" and the corresponding zone LED flashes three times per second to signal that
an alarm occurred and the alarm zone in which it occurred.
• Press the key switch again until two beeps sound. Then the alarm message is deleted from the alarm
system memory. The LED "ZONE STATUS" and the corresponding zone LED are deactivated. The alarm
system is now deactivated and ready for re-activation.
13. Overview of the Otical and Acoustic Signals
"ZONE STATUS" LED:
Event
System deactivated
Exit delay active + error in alarm zone
Exit delay active + all alarm zones ok
System activated
Alarm is or was present
System stored alarm
An alarm zone was set to bypass
The operating voltage was switched on or the
system is in standby
30
LED
Off
Lit
Flashes
Flashes twice per second
Flashes fast
Flashes thrice per second
Lit
Flashes alternatingly with the"SYSTEM STATUS"
LED