Submenu "Record Setting; A) Function "Record Mode - Renkforce 1505092 Bedienungsanleitung

16. Submenu "Record setting"

a) Function "Record mode"

The screen/DVR can perform recordings either time-controlled (e.g. only weekdays, 10 PM to 6 AM), by motion detec-
tion (if the picture content of the radio camera changes) or manually (by pushing a button).
Programming of the periods for timed recording is described in chapter 16. b); settings of the sensitivity at
motion detection can be found in chapter 16. c).
Proceed as follows:
• Briefly push the "Menu" button (5) on the screen/DVR or the "MENU" button on the IR remote control. Then the
main menu is displayed.
• Use the " " or the " " button to select the submenu "Record Setting" and then briefly push the "
• Use the " " or the " " button to select the function "Record Mode" and then briefly push the "
• Use the " " or the "
• Set the desired function for each of the radio cameras with the " " or the " " button.
"Schedule": Timed recording
"Motion": Recording at motion
"Manual": Manual recording by pushing a button
• Confirm the setting by pushing the "
• The screen/DVR then switches back to the previous menu. If you want to change the recording function for another
channel, proceed as described above.
• To switch one menu level back or to leave the OSD menu, briefly push the "Menu" button (5) on the screen/DVR or
the "MENU" button on the IR remote control (you may need to push it several times).
64
" button to select one of the four channels ("cam 1", "cam 2", "cam 3" or "cam 4").
" button briefly.
" button.
" button.