Tripp Lite SmartOnline SUINT1000LCD2U Bedienungsanleitung Seite 7

Basic Connection and Start-Up
6
Select UPS Battery Age Alert
Next, the UPS will prompt you to select the timing of the
BATTERY AGE ALERT.
Using the UP / DOWN
battery age alert in months, then press APPLY
Batt Age Alert
Months:36
Back Select Apply
SETUP
ESC
6
8 Plug your equipment into the UPS
Your UPS is designed to support network, server and computer
equipment only.
8
Your model and outlet may differ.
buttons, select the timing of the
.
7
Select Audible Alarm ENABLE / DISABLE status
Next, the UPS will prompt you to select the alarm ENABLE /
DISABLE status.
Using the UP / DOWN
DISABLE status, then press APPLY
Note: Disabling the alarm prevents the audible alarm from sounding during
power failures and UPS fault conditions only. The alarm will still "chirp" to
confirm operator input via the front panel LCD navigation buttons when the alarm
is set to disable.
Audible Alarm
Enabled
Disabled
Back Select Apply
ESC
7
9 Turn your UPS on
Press and hold the POWER
release as the alarm begins to sound.
9
The UPS will then go through a series of diagnostic checks
before turning on output power. Once the UPS reports the
operating status of NORMAL / LOAD PROTECTED with the
configured POWER STRATEGY enabled, your UPS can
immediately be put into service to provide reliable protection
from a wide variety of power problems.
7
buttons, select the alarm ENABLE /
.
SETUP
button for 3 seconds and