All Models - Tripp Lite SmartOnline SUINT1000LCD2U Bedienungsanleitung

Internal Battery Replacement
Battery Replacement Door: Under normal conditions, the original battery in your UPS will last several years. Battery replacement
should be performed only by qualified service personnel. Refer to "Battery Warnings" in the Safety section. If you require a replacement
battery, you can find it at www.tripplite.com/support/battery/index.cfm. See the chart below to find the right replacement battery for your
UPS system:
UPS Model
SUINT1000LCD2U
SUINT1500LCD2U
SUINT2200LCD2U
SUINT3000LCD2U / SU3000LCD2UHV
See the following diagrams for battery removal and installation procedures.

All Models

Note: The SUINT1000LCD2U is shown, but the procedure is the same for the other units.
1
Remove the four front screws from the front bezel and take
it off.
1
3
Open the front plate. Disconnect battery power cable and
communication cable.
3
5
Install new battery pack into the UPS in the same position as
the original pack.
5
Replacement Battery Cartridge
RBC24S
RBC36S
RBC48S
RBC72S
2
Loosen the two screws securing the front plate.
2
4
Remove old battery pack.
4
6
Reconnect battery power cable and communication cable.
Close the front plate.
6
24