Tripp Lite SmartOnline SUINT1000LCD2U Bedienungsanleitung Seite 21

Optional Connections
4
External Battery Connection
Check the Model Specific Accessories section under
Overview for compatible battery packs and maximum quantities
for your UPS system. Ensure that your battery pack matches
the voltage listed next to your UPS battery connector. Adding
external batteries will increase recharge time as well as
runtime. See the battery pack owner's manual for complete
installation and setup instructions. Make sure cables are fully
inserted into their connectors. Small sparks may result during
battery connection; this is normal. Do not connect or
4
Your model may differ.
disconnect battery packs when the UPS is running on battery
power.
IMPORTANT! In order for the runtime-remaining LCD and the software information screens to accurately predict runtime
with external battery packs connected, you must configure any connected packs using the front panel LCD or Tripp Lite's
External Battery Configuration software. See Configuring External Battery Packs section under Operations.
CAUTION: Do not open or mutilate batteries. Released material is harmful to the skin and eyes. It may be toxic. The following
precautions should be observed when working on batteries: Determine if the battery is inadvertently grounded. If inadvertently
grounded, remove the source from ground connection. Contact with any part of a grounded battery can result in electrical shock. The
likelihood of such a shock can be reduced if grounds are removed during installation and maintenance. (This is applicable to
equipment and remote battery supplies that do not have a grounded supply circuit.)
21