Special Safety Instructions - Parkside PSSAP 20-Li A1 Originalbetriebsanleitung

ensure that the safety of the power tool is
maintained.

Special safety instructions

1) Safety instructions for reciprocating
saws
Hold the electrical power tool by the
insulated handle surfaces when you
are undertaking work where there is
the danger of the attachment
striking hidden electricity cables.
Contact with a live wire can also charge metal
parts of the device, which may lead to electric
shock.
Keep hands away from the sawing area. Do
not reach underneath the work piece. Upon
contact with the blade there is a risk of injury.
Only when the electric tool is turned on should
the sawing blade be moved against the work
piece. There is a risk of kickback if the tool
insert jams in the work piece.
Make sure that the base plate is securely
placed against the work piece during sawing.
The saw blade can tilt and lead to loss of
control over the power tool.
After you have finished work, turn the power
tool off and do not pull the saw blade out of
the cut until it has come to a standstill. In this
way you will avoid any kickback and can
safely put down the power tool.
Use only undamaged saw blades in perfect
condition. Bent or blunt blades can break,
adversely affect the cut or cause kickback.
Do not brake the saw blade after switching the
device off by applying side pressure. The saw
blade may be damaged, break or cause a
kickback.
Tighten the material firmly. Do not support the
work piece by hand or foot. Do not touch any
objects or the ground with the saw running.
There is a risk of kickback.
Use suitable detectors in order to find hidden
supply lines or ask the local utility company.
Contact with electrical cables can lead to
electric shock and fire, contact with a gas pipe
can result in an explosion.
Damage to a water pipe can lead to property
damaged and electric shock.
Hold the power tool tightly with both hands
while working and ensure a secure footing. The
power tool is guided more securely with both
hands.
Secure the work piece. A work piece that is
retained with clamping devices or a vice is
held more securely than with your hand.
Wait until the power tool has stopped before
placing it down.
The tool insert can tilt and lead to loss of
control over the power tool.
Do not saw any materials (e.g. lead-based
paints and coatings or materials containing
asbestos) whose dust can be harmful.
2) SPECIAL SAFETY DIRECTIONS FOR
BATTERY-OPERATED TOOLS
Ensure that the device is switched off before
inserting the battery pack. Inserting a battery
pack into a power tool that is switched on may
result in accidents.
It should be noted that to charge battery packs
with the charger only indoors. The charger is
intended to charge only a certain type of
battery pack.
To reduce the electric shock hazard, unplug the
battery charger from the mains before cleaning
the charger.
Do not subject the battery pack to strong
sunlight over long periods and do not leave it
on a heater. Heat damages the battery pack
and there is a risk of explosion.
Allow a hot battery pack to cool before
charging.
Do not open up the battery pack and avoid
mechanical damage to the battery pack. Risk
of short circuit and fumes may be emitted that
ir ritate the respiratory tract. Ensure fresh air
and seek medical assistance in the event of
discomfort.
Do not use non-rechargeable batteries. This
could damage the appliance.
GB/IE 25