Installation And Connection - WMF 10 Bedienungsanleitung

Initial setup
2.2

Installation and connection

>
Unpack the coffee pad machine.
Hazard!
Risk of accidents for children at low installation height!
If the height of installation is too low, children can reach into the device and may be injured by hot steam or
water.
> Install the device at least 85 cm, if necessary, even higher, above the floor surface.
> Install the device on a surface with a width of at least 60cm.
> Push the device far to the rear so that the drip tray and the device are out of the reach of children.
Possible material damage to sensitive surfaces!
Due to the escaping hot steam or water, delicate installation surfaces can be damaged.
> Protect the delicate installation surfaces with a base that is water-proof and heat resistant.
> Ensure that the surface remains dry.
>
Place the coffee pad machine on a stable, horizontal base that is water-proof and heat-resistant. Keep the
machine away from heat sources (hotplate, gas flame etc.).
>
Place the drip tray grid in the drip tray. Note the position marking on the front right.
>
Insert the drip tray with the drip tray grid in the coffee pad machine.
>
Insert the plug of the mains cable in an electrical safety socket.
>
Protect the mains cable from damage:
- Do not clamp the mains cable.
- Protect the mains cable from sharp edges, moisture, heat or oil.
GB
6