Rinsing - WMF 10 Bedienungsanleitung

Caring for the coffee pad machine.
You can then carry out an express cleaning.
However, if the milk residues are already dry, then the only possibility is manual cleaning, as described in
Chapter "5.4.1 Milk foamer" on page 29 ff.
5.3

Rinsing

Rinse the appliance if it has not been used for several days. As a result, the content of the heating system
is replaced by fresh water.
Hazard!
Danger of scalding!
Hot steam is generated during the rinsing.
> Ensure that the milk foamer is mounted on the appliance and that there is a vessel below it.
Start the flushing immediately after switching on, even before the heating. This will save energy.
>
Rinse the water tank.
After rinsing the water tank, the pump initially sucks in air, which could make a loud noise. This is a
normal occurrence.
>
Before you put on the tank lid again, check whether the suction cap has been properly installed.
>
Fill the water tank through the filling opening in the tank lid up to its max-marking.
>
Insert the water tank into the appliance and close the door.
>
Ensure that the empty pad cassette is pushed in and rotate the locking knob to position
>
Fill the milk container with cold milk, place it on the right of the appliance and insert the milk hose into it.
>
Place a collecting vessel with a volume of at least 0.5 litres centrally under all spouts.
GB
.
26