Starting Operation; Setting The Finecoat Split-Gun Spray Gun - WAGNER FineCoat Betriebsanleitung

6.

Starting operation

Before connecting to the mains supply make
i
sure that the mains voltage corresponds to the
operating voltage on the rating plate. The unit must
be connected with a properly earthed shockproof
socket.
1. Screw air hose end (anti-kink spring) onto the turboblower.
Couple air hose to the paint spray gun.
2. Open closing lever on the paint container, remove paint
container.
3. Fill paint container with coating material.
4. Check that the paint container seal is clean and is seated
correctly.
5. Clip the container onto the spray gun and secure with the
closing lever.
6. Switch the turbo-blower on.
7. Point the paint spray gun at the object to be sprayed.
8. Determine the settings for the spray pattern, spray jet
width, amount of material, amount of air and ascending
feed pipe settings, see fig. 9 - 15 and the description page
18-20.
9. Operate trigger on the paint spray gun.
6.1

Setting the FineCoat Split-Gun spray gun

Spray pattern selection (fig. 9)
A = vertical flat jet for horizontal surfaces
B = horizontal flat jet for vertical surfaces
C = Round jet for corners and edges and places difficult to access.
A
FineCoat Split-Gun
B C
GB
Setting the required spray pattern (fig. 10)
Never pull trigger while adjusting the air cap
settings.
Attention
Turn the air cap (1) to the required spray pattern position.
Setting the spray jet width (fig. 11)
Adjusting ring
Turn to the right = wider spray jet
Turn to the left = narrower spray jet
i
The adjusting ring does not fasten the air cap!
An ideal starting point is when the triangle mark on
the air cap ring (1) is aligned with the triangle mark
on the gun head (2).
Setting the amount of material (fig. 12)
Set the amount of material by turning the material adjustment knob.
Turn to the left = more material
Turn to the right = less material
19
Starting operation
1
2
1