Troubleshooting - Panasonic GP-US932CSXE Bedienungsanleitung

Troubleshooting

Before asking for repairs, check the symptoms with the following table.
Contact your dealer if a problem cannot be solved even after checking and trying the solution in the table or a problem is not
described below.
Symptom
No image displayed
Camera with no response to
the button operation on the
front face of the CCU
The lighting indicator of the
[SCENE] button unchanged
The lighting indicator of the
[GAIN] button unchanged
Only the color bar displayed
The hue [MATRIX] unadjust-
able in the menu
Blurred whole screen
Plural edges visible
"AWC OK" not displayed
Black bars at right and left of
image
Vertically longer image
No sound from monitor
32
Cause/solution
• Are the cables appropriately connected to the video output con-
nector, S-VIDEO output connector, RGB/YPbPr output connector,
HDMI output connector or SDI output connector?
Check whether the connection is appropriately established.
• Is the video output signal format of each output connector compat-
ible with the video format displayable on the monitor?
Check whether the video output signal format is compatible with
the video format.
• Is the monitor brightness appropriately adjusted, or is the contrast
appropriately adjusted?
Check whether the monitor settings are appropriate.
• Is the function setup switch No. 4 set to "ON"?
Set the function setup switch No. 4 to "ON".
• Pressing once displays the state.
Press the [SCENE] button repeatedly until your target indicator
lights.
• Pressing once displays the state.
Press the [GAIN] button repeatedly until your target indicator lights.
• Is the camera cable appropriately connected at both the connector
of the CCU and the connector of the camera head?
Check whether the connection is appropriately established.
• Is the camera cable appropriately connected at both the connector
of the CCU and the connector of the camera head?
Connection between the camera head and camera cable is
required to adjust the image quality.
Check whether the connection is appropriately established.
• Is the lens aperture appropriately adjusted?
Check whether the aperture is appropriately adjusted.
Use lenses with recommended F number or higher and 3CCD-
specific lenses.
• Try to change the setting of "DTL MODE".
• Change the monitor cable.
• When the screen is too bright, narrow the lens aperture or set
"ELC" to "ON".
• This phenomenon depends on the specifications of the monitor.
Select the wide and full screen display at the monitor side.
• This unit provides outputs on the assumption that the screen is
16:9.
Select the wide screen display at the monitor side.
• When the SD format output is applied, check whether the SD
ASPECT setting in the SETUP menu is appropriate.
• This unit is not applicable to sound output.
Reference
pages
11, 12
11, 21
–
11
9
10
9
9
15
22
–
15, 19
–
–
30
–