Elc Setting [Elc] - Panasonic GP-US932CSXE Bedienungsanleitung

w ELC setting [ELC]
Setting ELC (electronic light control) to ON provides automatic adjustment of the screen brightness. The convergence level of
ELC can be specified at "BRIGHTNESS" in the SEL menu (☞ page 31).
If bright light such as a spotlight is present in the background behind a subject, the subject may appear dark. To eliminate this
phenomenon, masking bright areas allows users to perform backlight compensation to hide bright areas.
Top screen of SETUP menu
** SET UP ** P1
CAMERA ID *OFF
ELC *OFF
SHUTTER OFF
GAIN OFF
SENS UP OFF
BINNING OFF
OUTPUT SEL RGB
HDMI OUTPUT YPbPr(422)
END
Step 1
Set "ELC" to "ON" and press the [SEL] button.
The "ELC CONT" screen appears.
→
Step 2
Move the cursor to "AREA" and use the [e] or [f] button
to select an area.
The area is selectable from the following:
* The detection areas shown in the drawings below are not
displayed.
ALL (default): The detection target is the whole area
on the screen.
S CIRCLE: The detection target is the small circle area
in the center of the screen.
M CIRCLE: The detection target is the medium circle
area in the center of the screen.
"ELC CONT" screen
** ELC CONT **
AREA ALL
.... .... 4
PEAK/AVE |
P A
RET END
L CIRCLE: The detection target is the large circle area
MANU: The detection target is manually specified.
AUTO: Dark areas are automatically masked, and only
Step 3
Move the cursor to "PEAK/AVE" and use the [e] or [f] but-
ton to adjust the detection level.
When the cursor is moved in the "P" direction, the peak
value (maximum value) is detected. When the cursor is
moved in the "A" direction, the average value is detected.
in the center of the screen.
(☞ Page 20)
bright areas are detected.
19