White Balance Setting [White Bal] - Panasonic GP-US932CSXE Bedienungsanleitung

!0 White balance setting [WHITE BAL]

Select a method of white balance adjustment from the following.
AWC (default): Activates the automatic white balance control mode. This adjustment is suitable for a location where a light
source is stable.
When "AWC" is selected, the operation to adjust the white balance is required.
ATW: Activates the automatic white balance tracking mode. The camera constantly checks and automatically adjusts the white
balance.
If the situation meets one of the following or other, color may not be accurately reproduced. In this case, perform "AWC" to
adjust the white balance.
• The subject is mostly highly-colored.
• The photographic atmosphere is under the bright blue sky or at nightfall.
• The illumination of the light illuminating the subject is low or too high.
MANU: Manually adjusts the white balance.
When "AWC" is selected, follow the steps below to adjust the white balance.
Step 1
Aim the camera at a white subject.
Note:
• The destination to save "AWC" can be specified for each scene file. (
• If "AWC NG" appears and the indicator stays on or if the indicator lights when a scene file is changed, retry the steps 1 and
2.
• If the setting value for "R-GAIN" or "B-GAIN" of "MANU" is not the default (128), the white balance may not be properly
adjusted even when AWC is performed.
When "MANU" is selected, follow the steps below to adjust the white balance.
Step 1
Select "MANU", and then press the [SEL] button.
The "WHITE BAL" screen appears.
→
Step 2
Move the cursor to "R-GAIN" or "B-GAIN" and use the [e]
or [f] button to select the white balance.
Step 2
Hold down the [BAR AWC ] button on the front face of the
CCU for 2 seconds or more.
AWC starts, and the indicator of the [BAR
→
ton blinks. The adjustment is completed when the desti-
nation and "AWC OK" appear and the indicator goes
off.
☞ Page 26)
"WHITE BAL" screen
** WHITE BAL **
.... .... 128
R-GAIN
|
+
−
.... .... 128
B-GAIN
|
+
−
RET END
AWC ] but-
27