Gain Adjustment [Gain]; Electronic Sensitivity Enhancement Setting [Sens Up]; Binning Setting [Binning]; Rgb/Ypbpr Output Signal Setting [Output Sel] - Panasonic GP-US932CSXE Bedienungsanleitung

r Gain adjustment [GAIN]
Select a gain control setting from the following:
OFF (default): No gain adjustment
AUTO(L), AUTO(H): Automatic gain adjustment (The gain to be set will be the maximum value for automatic adjustment.)
MANU(L), MANU(H): Manual gain adjustment (The gain will be fixed to the setting value.)
Fine adjustment of gain level
The gain can be finely adjusted in both "LOW" and "HIGH" levels.
Step 1
Select an adjustment method in "GAIN" and press the [SEL]
button.
The "GAIN LEVEL" screen appears.
→
Step 2
Move the cursor to "HIGH" or "LOW" and adjust the level by
pressing the [e] and [f] buttons.
Important:
• The "LOW" level cannot be larger than the "HIGH" level.
• When "SENS UP" is set to "OFF" or "---", "AUTO(L)" is not available.
• "MANU(L)" and "MANU(H)" are not available when "SENS UP" is set to "AUTO (x2)", "AUTO (x4)" or "AUTO (x8)".
t Electronic sensitivity enhancement setting [SENS UP]
The magnification of the electronic sensitivity is selectable from the following:
OFF (default), AUTO (x2), AUTO (x4), AUTO (x8), MANU (x2), MANU (x4), MANU (x8)
When "AUTO" is selected, the magnification to be set will be the maximum value for automatic adjustment.
When "MANU" is selected, the magnification will be fixed to the setting value.
Note:
• When "MANU (x2)", "MANU (x4)" or "MANU (x8)" is selected, set "ELC" to "OFF". (
• When "GAIN" is set to "OFF" or to a low level, image may become grainy and unstable. In such a case, adjust the electronic
sensitivity.
• When "SHUTTER" is set to other than "OFF", "---" appears and the electronic sensitivity enhancement function is not avail-
able. (☞ Page 20)
• When the electronic sensitivity enhancement function is used, time for the image sensor readout is elongated to enhance
the sensitivity. Therefore, the residual image of a moving subject is increased in accordance with the magnification of the
sensitivity.
y Binning setting [BINNING]
The following are available for the binning:
OFF(default): No binning
ON: Performs binning.
AUTO: Automatically adjusts the binning setting in accordance with the brightness of the image.
u RGB/YPbPr output signal setting [OUTPUT SEL]
The output signals of the RGB/YPbPr output connector are specified.
RGB (default), YPbPr
i HDMI output signal setting [HDMI OUTPUT]
The output signals of the HDMI output connector are specified.
YPbPr (422) (default), YPbPr (444), RGB (NOR), RGB (ENH)
The HDMI image output may be interrupted for several seconds when the HDMI output signal setting or video format setting is
changed.
"GAIN LEVEL" screen
** GAIN LEVEL **
... | ..... 4
LOW
+
−
........ | 10
HIGH
+
−
RET END
☞ Page 19)
21