Machine Accessories; Attachments; Maintenance; Advice For Use - Zummo ZG14 Bedienungsanleitung

9
The machine has various squeezing sets of Cups, Balls and Fruit Classifiers to use depending
on the size of the fruit you wish to squeeze.
10
Exterior machine maintenance: Consists of just daily cleaning.
Interior of the machine: After every 600,000 cycles, the inner machine guides and springs must
be lubricated and a full cleaning carried out.
11
x
x
x
x
x
12
Damage
The display is not lit
The display shows message
Error
18
Downloaded from www.Manualslib.com

MACHINE ACCESSORIES

a Dark grey-coloured Cups and Balls plus Hopper Fruit Classifier Balls for fruits
with diameters between 55 and 75 mm (Fig.18).
b Light grey-coloured Cups and Balls plus Hopper Fruit Classifier for fruits with
diameters between 70 and 90 mm (Fig. 17).
c Very light grey-coloured Cups and Balls plus Hopper Fruit Classifier for fruits
with diameters between 53 and 60mm (Fig. 19) (Optional set not included with
the machine)
Regardless of the squeezing set use, the Blade will always be the same.
ATTENTION!: Never mix components of different sets.
MACHINE MAINTENANCE

ADVICE FOR USE

Always make sure you are using the right squeezing set of Balls, Cups and Fruit Classifier
for the size of fruit you wish to squeeze. If the fruit to squeeze is too big or too small for the
squeezing kit used, the quality of the juice may decrease, resulting in a bitter juice flavour.
The Hopper Fruit Classifier must be correctly selected according to the size of the fruit to
squeeze.
If fruits are too large for the Fruit Classifier, the fruit will not fall into the Cup.
If fruits are otherwise too small, numerous pieces of fruits will fall at the same time into the
Cup.
We recommend to switch off the machine when is not in use. (Fig. 3)

IDENTIFYING DAMAGES

Cause and/or solution
No power supply.
Fuse burnt out. (Fig. 16)
Power cable not properly connected.
Switch power on. (Fig. 3)
Damp circuit board. Supply dry heat to the board.
Casing not fitted correctly (Disp. 5). (Fig. 7)
Hopper Track not fitted correctly. (Disp. 5)
Faucet Tray not assembled or incorrectly assembled (Disp. 6). (Fig.8)
manuals search engine
Disp. 5 Disp. 6