Accessories; Maintenance; Use Recommendations - Zummo Z06 Bedienungsanleitung

Assembly
After everything is washed, put it back in place in the following order:
1 Screw on the balls is the tray that holds the squeezers. Make sure that washers are put in
place beforehand and that the balls are properly tightened.
2 Check that the rubber bands of the blade are properly in place (Figs. 19 & 20). Insert the blade
inside the tray. Assemble this set on the machine's three shafts simultaneously. (Fig. 12).
Never mount the blade on the tray afterwards!! When it makes contact with the bottom, fit
the projecting part of the blade into the front guide (Fig. 13).
3 Place the cups on the shafts and tighten the fastening nuts.
4 The cover is put back in place by fitting its clasps into the slots located on both front sides
(make sure that the clasps fit correctly into the slots). (Fig. 8 y 9)
Before starting up the machine, make sure that:

The tray and blade have been properly fitted into place and screwed down.

The blade has been properly fitted into place and in the horizontal position.

The nuts on the cups are properly tightened.

The correct sets of balls and cups have been used (see the section entitled

"accessories").

In the event that the tray, balls or cups were not properly fitted into place, damage may be done to
these pieces and the inside of the machine. (Problems not covered by the guarantee since they are
errors made by the operator).
Cleaning the loader
Lift the loader up and it will come off easily, with the top of the machine remaining totally uncovered.
After cleaning it, put it back in place by fitting the legs into their respective openings. (Fig. 14)
9
ACCESSORIES
Depending on the size of the fruit that you want to squeeze, the machine has several different sets of
cups and balls to choose from:
a Dark-coloured Cups and Balls for fruits with diameters between 55 and 75 mm. (Fig.
15).
b Bright-coloured Cups and Balls for fruits with diameters between 70 and 90 mm. (Fig.
16).
c (Optional). Small red cups and balls for fruit with a diameter between 45 – 60mm.
(Fig. 17).
Regardless of the set used, the blade and the squeezing tray will always remain the same.
ATTENTION!! Do not mix elements of different sets together.
10

MAINTENANCE

The only maintenance that the machine requires is to periodically lubricate the paddle shaft. (Fig. 18).
Always use grease approved for use with food products.
Interior of the machine: After every 600,000 cycles, the inner machine guides and springs must be
lubricated and a full cleaning carried out.
11

USE RECOMMENDATIONS

 Make sure you are using the right squeezing parts (Balls & Cups) for the size of fruit you wish to
squeeze. If the fruit to squeeze is too big or too small for the squeezing kit used, the quality of the
juice may decrease, getting a bitter juice flavour.
 We recommend to switch off the machine when is not going to be use. (Fig. 6)
14