Yamaha WR400F Fahrer- Und Wartungshandbuch Seite 426

CRANKCASE AND CRANKSHAFT
4 - 82
REMOVAL POINTS
EC4N3210
Crankcase
1. Separate:
Crankcase (right)
Crankcase (left)
Separation steps:
Remove the crankcase bolts, hose guide
and clutch cable holder.
NOTE:
Loosen each bolt 1/4 of a turn at a time and
after all the bolts are loosened, remove
them.
Remove the crankcase (right).
NOTE:
For this removal, slits in the crankcase.
As pressure is applied, alternately tap on
the transmission shafts, shift cam and
crankshaft.
CAUTION:
Use soft hammer to tap on the case half.
Tap only on reinforced portions of case.
Do not tap on gasket mating surface.
Work slowly and carefully. Make sure the
case halves separate evenly. If one end
"hangs up", take pressure off the push
screw, realign, and start over. If the
cases do not separate, check for a
remaining case screw or fitting. Do not
force.
Remove the dowel pins and O-ring.
ENG