Yamaha WR400F Fahrer- Und Wartungshandbuch Seite 150

Ô Fasten the TPS lead under the
coupler to the frame with a
plastic locking tie.
Pass the carburetor breather
hose and overflow
between the connecting rod
and cross tube (frame).
Ò Fasten the neutral switch lead
and oil hose together with a
plastic locking tie.
˜ Fasten the neutral switch lead
to the frame with a plastic
band.
ˆ Fasten
the cylinder
breather hose with the hose
holder.
Ø Fasten the neutral switch lead
and CDI magneto
together with a plastic band.
∏ Pass the clutch cable through
the cable guide.
CABLE ROUTING DIAGRAM
ΠPass
the
breather hose along the inner
side of the radiator pipe.
 Pass the clutch cable between
hose the frame and radiator and
over the lower boss on the
radiator.
Í Pass the neutral switch lead
and CDI magneto lead over
the middle radiator mounting
boss. Then, pass the decom-
pression cable under the mid-
dle radiator mounting boss
head and along the left side of the
neutral switch lead and CDI
magneto lead.
Ê Pass the clutch cable through
lead the cable guide.
Ë Fit the brake hose into the
guide on the protector.
cylinder head
2 - 22
SPEC
◊ Fasten the ignition coil lead
(in the sub wire harness) on
the upper inside of the frame
and cut off the tie end.
„ Pass the ignition coil lead (in
the sub wire harness) under
the cushion bracket (frame).
≈ Fasten the ignition coil lead
(in the sub wire harness) to
the frame with a plastic lock-
ing tie and cut off the tie end.
Á Pass the carburetor breather
hoses and overflow hose so
that all there hoses do not
contact the rear
absorber.
shock