GB
IE
Replacing carbon brushes
Switch the device off and remove
the mains plug. Allow the device to
cool down.
1. Loosen the service panel (6) with
a screwdriver.
2. Remove the service panel (6).
3. Pull the carbon brush (10) out of
the holder.
4. Slide a new carbon brush (10)
into the holder.
5. Re-attach the service panel (6).
6. Repeat steps 1 to 5 on the other
side of the tool.
Carbon brushes must only be re-
placed in pairs.
Replacement parts/accessories
Spare parts and accessories can be obtained at
If you do not have internet access, please contact the Service Centre via telephone
(see "Service-Center" Page 24). Please have the order number mentioned below ready.
Spare carbon brushes ............................................................................. 91104351
Socket set: 4 sockets
(17mm, 19mm, 21mm, 22mm) ............................................................. 91104352
Socket set:
10 sockets
(10mm,12mm,13mm,16mm,17mm, 18mm, 19mm, 21mm, 22mm, 24mm) 91104353
22
Storage
•
•
Disposal and protection
of the environment
Take the device, accessories and packag-
ing for environmentally friendly recycling.
•
•
www.grizzly-service.eu
Clean the device prior to storage.
Store the device in the storage case
9) provided in a dry place and out
(
of reach of children.
Machines do not belong with
domestic waste.
Return the unit to a recycling centre.
The plastics and metals in the unit can
be sorted and appropriately recycled.
Ask our Service Centre for details.
Defective units returned to us will be
disposed of for free.