Service; Appliance-Specific Safety Instructions For Grinders; Operation; Tensioning/Replacing The Abrasive Belt - Parkside PBS 600 B1 Bedienungsanleitung

5. Service

a) Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of
the power tool is maintained.
Appliance-specific safety instructions
for sanders
■ Only hold the appliance using the insulated
handle surfaces, as the abrasive belt
damage its own power cable. Contact with a
live wire may apply voltage to exposed metal
parts of the power tool and could give the oper-
ator an electric shock.
WARNING!
■ Dusts from materials such as leaded paint,
some types of wood and metal can be harmful
to your health.
■ Contact with or inhalation of these dusts can
represent a health hazard for the person
operating the appliance and other people
in the vicinity.
■ Wear safety goggles and a protective dust
mask!
PBS 600 B1

Operation

Tensioning/replacing the abrasive belt

WARNING – RISK OF INJURY!
■ Always remove the power plug from the wall
socket before carrying out any work.
1. Loosen the clamping appliance for the abrasive
belt by swivelling the clamping lever
pletely out (see Fig. B). The abrasive belt
can
can now be removed.
2. Now attach a new abrasive belt
suitable for another material or with a different
grain size.
IMPORTANT: The direction of the arrows on
the inside of the abrasive belt
appliance housing must match.
3. Push the clamping lever
position.
Manually adjusting the abrasive belt
If the abrasive belt does not run centrally after
switching on, you will have to adjust the belt tracking
manually.
♦ To do this, turn the adjusting screw
front roller until the abrasive belt
centrally.
IMPORTANT: It is imperative to ensure that
the abrasive belt
housing. Check the belt tracking regularly,
and readjust it using the adjusting screw
necessary.
com-
or one
and on the
back to its original
:
on the
runs
does not rub against the
│
GB 15
if
■