Waeco MAGIC WATCH MWE-1000-4FM Bedienungsanleitung Seite 40

_MWE-1000-4FM.book Seite 40 Dienstag, 9. August 2005 11:30 11
Installing MAGIC WATCH
Note that the installation angle depends on the installation height
(b and c, page 7).
The installation location should be as flat as possible.
Fit the sensors at regular intervals along the total width of the vehicle in
order to guarantee optimum monitoring (d, page 7).
Note that the sensors must be aligned in a particular direction. The top
side of the sensor is labelled with "▲" (e, page 7).
So that the corners of the vehicle (indicators etc.) can be monitored, the
outer sensors must be fitted as far as possible to the left and right (d,
page 7).
It is possible to paint the sensors, but not with a multicoat paint, as this
impairs the functionality of the sensors.
Installing the MWE-1000-4FM
To perform the installation, proceed as follows:
➤ Choose an installation location on the bumper which is as perpendicular
to the road surface as possible (e, page 7).
Caution
Before making any drill holes, ensure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
➤ For each sensor, drill a hole with a diameter of 24 mm in the bumper.
➤ Remove the hex nut and the outer spacer ring of the sensor.
➤ Guide the cables of the sensors through the corresponding hole.
➤ Insert each sensor into its hole and fasten it by putting on the spacer ring
and screwing the nut onto the sensor thread behind the bumper.
Installing the MW-1000-4FM
To perform the installation, proceed as follows:
➤ Choose an installation location on the bumper which is as perpendicular
to the road surface as possible (f, page 7).
Note
The surfaces to be bonded must be clean, dry and free of grease.
➤ Pull the protective foil from the adhesive tape for each sensor, and fasten
the sensors.
40
magic watch