Installing Magic Watch; Tools Required; Mounting The Sensors - Waeco MAGIC WATCH MWE-1000-4FM Bedienungsanleitung

_MWE-1000-4FM.book Seite 39 Dienstag, 9. August 2005 11:30 11
magic watch
6

Installing MAGIC WATCH

6.1

Tools required

For installation and assembly you will require the following tools:
Drill bit set (1 1, page 3)
Drill (1 2, page 3)
Screwdriver (1 3, page 3)
Set of ring or open-ended spanners (see 1 4, page 3)
To make and test the electrical connection, the following tools are required:
Diode test lamp (1 5, page 3) or voltmeter (1 6, page 3)
Crimping tool (1 7, page 3)
Insulating tape (see 1 8, page 3)
Cable bushing sleeves, if necessary
To fasten the control box and the cable you may require additional screws
and cable binders.
6.2

Mounting the sensors

When fitting the sensors, make sure no there are no objects fixed
to the vehicle (e. g. bicycle racks) which are in the detection range
of the sensors.
The sensors must be correctly aligned for the device to
work properly.
If these point to the ground, irregular ground surfaces such
as bumps may be interpreted as obstacles. If they point too
far up, obstacles will not be detected at all.
The top side of the sensors is labelled with "▲" (e, page 7).
Note the following information during installation:
The distance from the sensors to the ground should be between 40 cm
and a maximum of 60 cm (b and c, page 7).
Installing MAGIC WATCH
39