Continuous Measurement - Pce Instruments Pce-Lds 70 Bedienungsanleitung

7.2

Continuous measurement

ACHTUNG: Never look into the laser beam directly and do not direct it towards any
person or animal as this can cause eye injuries.
To make a continuous measurement, follow these steps:
1. Make sure your device is connected to your computer.
2. Supply the PCE-LDS 70 with the right supply voltage.
Caution: The distance meter is ready to measure and emits a laser beam.
The Power LED will glow.
3. Establish a connection to the PCE-LDS 70 by clicking on the
4. In the main menu, click on the button
The meter will now make measurements approx. every 0.5 ... 1.5 seconds (depending
5.
on the distance and the reflectivity).
An audible signal will sound every time a measurement is made.
6. If you have activated the computer screen
below the main menu.
7. If you have activated the button
8. Press the
, the following data will be saved to a file:
button to stop the continuous measurement.
© PCE Instruments
24
.
, the reading will appear in the chart
button.