Operation; Single Measurement - Pce Instruments Pce-Lds 70 Bedienungsanleitung

7

Operation

7.1

Single measurement

ACHTUNG: Never look into the laser beam directly and do not direct it towards any
person or animal as this can cause eye injuries.
To make a single measurement, follow these steps:
1. Make sure your device is connected to your computer.
2. Connect the mains plug to a power source. The Power LED will glow.
Caution: The distance meter is ready to measure and the laser is turned on.
3. Aim the device at the object to be measured.
4. Connect the meter to your computer. The tick icon must be filled
5. In the main menu, click on the button
An audible signal will sound and the meter carries out a single measurement.
6. If you have activated the computer screen
below the main menu.
7. If you have activated the button
8. Make as many single measurements as desired, following the same procedure.
.
, the reading will appear in the chart
, the following will be saved to a file:
© PCE Instruments
23
.