Limbing; Bucking - FLORABEST FKS 2200 G4 Originalbetriebsanleitung

Never step in front of a tree
which is notched.
4. Felling back cut (B):
the chainsaw pulling. The back
cut must run horizontally 5 cm
above the horizontal notched cut.
The back cut should be so deep
that the separation distance be-
tween the back cut and the notch
log not sawed through is desig-
nated as a break dimension.
direction. Do not cut through the
hinge.
chainsaw is stuck, discontinue the
tic or aluminium wedges to open
5.
bar into the back cut, as soon as
chain bar.
6
two cuts.
As soon as the tree begins to
fall, pull out the saw from the
section, stop the motor, place
the electric chainsaw down
and leave the workplace us-
ing the withdrawal path.
Pay attention to falling
branches and do not stumble.

Limbing

Many accidents occur during the
limbs when you are standing on the
log. Keep the spring-back area in
• Do not remove support branches until
• Branches under tension must be sawed
-
• When working on thicker branches, use
the same technique as when you are
-
-
Figure , in one go.

Bucking

into smaller sections.
• Ensure that the saw chain does not
come in contact with the ground during
sawing.
G B M T
-
4 7