Assembly; Mounting The Saw Chain And Blade - FLORABEST FKS 2200 G4 Originalbetriebsanleitung

G B
M T
14 Switch-on block
The switch-on block must be
device.
18 Chain catcher

Assembly

Always wear protective
gloves when working with
the chainsaw and employ
only original parts. Pull out
the power plug before doing
any work on the chainsaw
itself -– injury hazard!
operation, you must:
- install the blade, saw chain and chain
cover where necessary,
- adjust the saw chain tension,
- pour in chain oil,
and the automatic oil pump.
Mounting the saw chain and
blade
2
clockwise
the sprocket chain wheel cover-
ing (8).
3. Spread the chain (5) out into a
loop with the cutting edges run-
ning clockwise .
4. Slide the saw chain (5) into the
bar guide groove. To mount the
guide bar (4), raise it to an angle
make it easier to replace the saw
chain (5) onto the sprocket (24).
4 2
anti-
( ) to remove
5
5. Place the chain bar (4) and saw
chain (5) on the bar bolts (23).
When the nose on the right be-
low the bar bolt (23) sits in the
round recess on the blade, the
blade is placed correctly. It is nor-
It is normal that the saw chain (5)
is slack.
6. Pre-tension the saw chain (5) by
quick-tensioning system (9) in
clockwise direction.
7. Position the sprocket chain wheel
covering (8). First place the tab
(25) on the cover into the corre-
sponding notch on the plate (8).
Note that the saw can re-oil.
side or on the head. This is a normal
process due to the necessary ventilation
As each saw is checked during production
and tested with oil, a small residue may
be in the tank despite draining, which may
slightly dirty the housing with oil in transit.
Please clean the housing with a cloth.
dirt deposits available can cause the chain
also absorb the chain oil. So the conse-
quence would be that the chain oil would
would be reduced.
5