Inserting/Replacing Activated Charcoal Filters - hanseatic SY-3503B1-P1-C13-L41-600 Gebrauchsanleitung

(16) (17)
5. Place a grease filter (16) with the pins into
the openings.
6. Push the lock (17) down; snap the grease
filter (16) shut and release the lock again.
7. Repeat the last two steps for the second
grease filter.
8. Switch the power back on.
Inserting/replacing activated
charcoal filters
The activated coal filters remove odours.
They have to be replaced as soon as the
cooking odours can no longer be adequately
filtered. If used frequently, you should change
the filters regularly. Check them at least every
6 months. For the source of supply, please
see chapter „Our Service Centre" on page
GB-20.
1. Unplug the mains plug or switch off the
corresponding circuit.
Care and maintenance
(17)
2. Open the lock (17) on one grease
filter (16) and carefully remove the grease
filter.
3. Repeat this step for the second grease
filter.
4. Only when replacing: Loosen the acti-
vated charcoal filters (18) in a clockwise
direction and then remove them.
5. Place the new activated charcoal fil-
ters (18) to the right and left of the motor
as shown and tighten them in an an-
ti-clockwise direction. Allow the locks to
snap into place.
Page GB-17
(16)