Mains Connection; Connecting The Pressure Line; Adjustment Of The Float Switch - FLORABEST FTS 1100 D4 Originalbetriebsanleitung

Mains Connection

The pump you have purchases is already
is designed for connection to an earthed
wall socket with a residual current operat-
Connecting the Pressure
Line
The pump is installed
1. Screw the quick-connect adapter
(9) onto the pump outlet (6).
2. Press the red release button on
the quick-connect adapter (9)
and slide the angle adapter with
quick-connect connector (10)
into the quick-connect adapter
(9). Let go of the red release but-
ton again.
3. Fit the hose over the reducer (11)
and secure it with a hose clamp.
Or use a screw connection on
the angle adapter with quick-
connect connector (10), or on
the reducer (11).
Œ
Outlet with a 1½" internal thread on
the pump for connection of the quick-
connect adapter (9) or for direct con-
nection of a hose with a 1½" external
Outlet with 1½" external thread at the

bracket adapter (10) for connection of
the reducer (9) or a 1½" screw con-
Outlet on reducer (9) for connection of
Ž
a 1¼" or 1½" hose as a compression
23 5
Outlet with 1" external thread at the

reducer (9) for connection of a 1"
Outlet with 1½" thread at the reducer

(9) for connection of a 1"hose as clamp
Note that the particle size may
be max. 19 mm if the reducer
19 3
the reducer and hose can become
blocked.
Adjustment of the float
switch
it can be started up immediately.
In the case of stationary installa-
tion, check regularly (no less then
once every three months) that the
( 7
switch height adjustment (8) and
move it to the desired position.
- It must be positioned so that it
can lift and lower freely. The
switching point heights "On"
and "Off" must be easy to
reach.
carefully by hand and then low-
er it again. In this case, you can
see whether the pump switches
on and off.
G B
7) is adjusted so that
( 7) is working.
13
7).
I E
7)
2 3