Selecting A Sandpaper Disc; Fitting The Sandpaper Disc; Lubrication - Parkside PDEXS 150 B2 Originalbetriebsanleitung

WARNING!
► Never operate the compressed air-powered
random orbital sander without the protective
cuff .
► Never operate the compressed air-powered
random orbital sander with an inverted
protective cuff .
► A damaged protective cuff
replaced immediately.
♦ Turn the spindle lock
towards the flat side of the eccentric spindle
(see Fig. 2).
Fig. 2
♦ Remove the protective cap from the threaded
rod of the grinding disc
wise into the eccentric spindle
stop.
♦ Undo the spindle lock
spindle can turn freely on its own axis.
CAUTION!
► Never operate the compressed air-powered
random orbital sander with a locked drive
spindle. This is dangerous and can result in
serious injuries.

Selecting a sandpaper disc

Erosion and surface:
The material removal rate and surface quality are
determined by the grain strength of the sandpaper.
■ Please note that you can use sandpapers with
various grain sizes for working the different
materials.
PDEXS 150 B2
should be
with the knurled bulge
and screw it clock-
as far as the
so that the eccentric

Fitting the sandpaper disc

CAUTION!
► Ensure that the appliance is disconnected from
the compressed air source before you fit or
remove a sandpaper disc
♦ The grinding disc
discs are equipped with matching Velcro
fasteners.
♦ Select the sandpaper disc
grain and press it onto the grinding disc
Ensure that it is centred.
♦ To change the sandpaper disc
side and pull it off the grinding disc
Clean the grinding disc
compressed air.

Lubrication

NOTE
► To avoid friction and corrosion damage,
regular lubrication is particularly important.
We recommend using a suitable special oil
for compressed air appliances (e.g. Liqui
Moly compressor oil).
–
Lubrication with mist oiler:
A mist oiler (not supplied) continuously
and optimally lubricates the appliance as
a preparation stage after the pressure re-
ducer. A mist oiler gives off fine drops of
oil into the air flow and thus guarantees
a regular lubrication.
–
Manual lubrication:
If you do not have a mist oiler, lubricate
the appliance before every use or longer
work sessions by dripping 3–4 drops of
special oil for compressed air appliances
into the connector nipple
.
and the supplied sandpaper
with the desired
.
, lift it from the
.
as required with
.
GB
CY
7