Before Use; Fitting The Connector Nipple; Fitting The Sanding Disc; Selecting A Sandpaper Disc - Parkside PDEXS 150 B2 Originalbetriebsanleitung

Before use

NOTE
► The sander may only be operated on
cleaned, oil-atomised compressed air and
may not exceed the maximum operating
pressure of 6.3 bar at the appliance. The
compressor must be fitted with a pressure
reducer to regulate the working pressure.
► Wind the Teflon tape
threaded connectors.

Fitting the connector nipple

♦ Remove the plastic protective cap from the
appliance's air inlet.
♦ Wrap the threads on the connector nipple
with the Teflon tape
♦ Screw the connector nipple

Fitting the sanding disc

The compressed air-powered random orbital sander
is equipped with a protective cuff
■ Rotation direction indicator of the
sanding disc
♦ To fit or replace the sanding disc
protective cuff (see Fig. 1).
Fig. 1
WARNING!
► Never operate the compressed air-powered
random orbital sander without the protective
cuff .
► Never operate the compressed air-powered
random orbital sander with an inverted
protective cuff .
► A damaged protective cuff
replaced immediately.
PDEXS 150 B2
supplied around all
supplied.
into the air inlet.
.
invert the
should be
♦ Turn the spindle lock
towards the flat side of the eccentric spindle
(see Fig. 2).
Fig. 2
♦ Remove the protective cap from the threaded
rod of the sanding disc
wise into the eccentric spindle
stop.
♦ Undo the spindle lock
spindle can turn freely on its own axis.
CAUTION!
► Never operate the compressed air-powered
random orbital sander with a locked drive
spindle. This is dangerous and can result in
serious injuries.
♦ Evert the protective cuff
♦ Fig. 3

Selecting a sandpaper disc

Removal and surface:
The material removal rate and surface quality are
determined by the grain strength of the sandpaper.
■ Please note that you can use sandpapers with
various grain sizes for working the different
materials.
with the knurled bulge
and screw it clock-
as far as the
so that the eccentric
again (see Fig. 3).
33
GB