Symbols Used On The Appliance; General Power Tool Safety Warnings; Work Area Safety; Electrical Safety - Parkside PAH 1700 A1 Originalbetriebsanleitung

NOTE
► The vibration level specified in these instruc-
tions has been measured in accordance with
a standardised measuring procedure and
can be used for equipment comparisons . The
specified vibration emission value can also
be used to make an initial exposure estimate .
WARNING!
► The vibration level varies in accordance with
the use of the power tool and may be higher
than the value specified in these instructions
in some cases . Regular use of the power tool
in this way may cause the user to underesti-
mate the vibration . Try to keep the vibration
loads as low as possible . Measures to reduce
the vibration load are, e .g . wearing gloves
and limiting the working time . Wherein all
states of operation must be included (e .g .
times when the power tool is switched off and
times where the power tool is switched on but
running without load) .

Symbols used on the appliance

■ Read the operating instructions.
■ Wear hearing protection.
■
Wear a dust mask.
■ Wear safety goggles.
■ Wear safety gloves.
■ Earth before use.
■ Caution!
Fill with oil before first use!
CAUTION!
FILL WITH OIL
BEFORE FIRST
USE.
PAH 1700 A1
General Power Tool
Safety Warnings
WARNING!
► Read all safety warnings and all instruc-
tions. Failure to follow the warnings and
instructions may result in electric shock, fire
and/or serious injury .
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers
to your mains-operated (corded) power tool or
battery-operated (cordless) power tool .

1 . Work area safety

a) Keep work area clean and well lit. Cluttered
or dark areas invite accidents .
b) Do not operate power tools in explosive
atmospheres, such as in the presence of flam-
mable liquids, gases or dust. Power tools cre-
ate sparks which may ignite the dust or fumes .
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control .

2 . Electrical safety

a) Power tool plugs must match the outlet.
Never modify the plug in any way.
Do not use any adapter plugs with earthed
(grounded) power tools. Unmodified plugs
and matching outlets will reduce risk of electric
shock .
b) Avoid body contact with earthed or ground-
ed surfaces, such as pipes, radiators, ranges
and refrigerators. There is an increased risk
of electric shock if your body is earthed or
grounded .
GB │ IE │ 15 ■