Working Procedures; Use; Switching On And Off; Emptying The Dust Collector - Parkside PBSD 600 A1 Originalbetriebsanleitung

Removing the dust extraction adapter and
reducer for an external extraction appliance:
♦ Pull off the hose of the dust extraction appli-
ance .
♦ Remove the reducer
tion .
♦ Pull the dust extraction adapter
the connection .

Working procedures

A light grinding pressure is sufficient:
■ Apply minimal pressure when grinding . The belt
grinder's own weight is sufficient for a good
grinding result . In addition, working this way
helps to reduce the wear on the abrasive belt
and the surface of the workpiece will become
more smooth .
Removal and surface:
■ The material removal rate and surface quality
are determined by the belt speed and grain
strength of the abrasive belt
section "Selecting speed and abrasive belt") .
Grinding:
■ Place the appliance on the workpiece when
switched on and work at a moderate feed rate .
Guide the grinder in parallel and overlapping
sanding motions over the workpiece . To avoid
unpleasant transverse grinding marks, always
sand in the direction of the grain . After complet-
ing the task, lift the appliance from the work-
piece and then switch it off .
NOTE
► Always hold the appliance firmly with two
hands while working .
PBSD 600 A1
for external dust extrac-
upwards off
(see also the

Use

Switching on and off

While operating the belt grinder, you can choose
between instantaneous and continuous operation .
Switching to instantaneous operation:
♦ Press the ON/OFF switch
Switching off instantaneous operation:
♦ Release the ON/OFF switch
Switching to continuous operation:
♦ Press the ON/OFF switch
and then press the lock button
Switching off continuous operation:
♦ Press the ON/OFF switch
it .

Emptying the dust collector

The dust collector should be emptied after every
10 minutes of operation at least .
♦ Pull the dust collector
"Attaching/removing a dust extraction unit")
♦ Shake the dust collector
to empty it .
♦ Fit the dust collector
ance .
.
.
, keep it pressed in
.
and then release
off (see section
over a rubbish bin
back onto the appli-
GB │ IE │ NI │ 7 ■