Blow Function; Cleaning/Maintenance; Cleaning The Device; Cleaning & Maintenance - Parkside PNTS 1400 E2 Originalbetriebsanleitung

GB
If foam or liquid exits, switch off the
machine immediately.

Blow Function

Operation without the use of a filter
is recommended.
• Connect the suction hose (19) to the
connecting blower (15) on the motor
head (3).

Cleaning/Maintenance

Pull out the mains plug.
Danger of electric shock.
Always check the appliance before
use for any obvious faults such as
a defective mains cable, and have
these repaired or replaced.

Cleaning the device

Never hose the device down with
water. Never use aggressive clean-
ing agents or solvents. This could
damage the appliance.
• After use, empty the stainless steel con-
tainer ( 9):
- Opening the drain plug to allow the
vacuumed liquid to drain out (
10). A liquid residue remains in the
container.
To remove all residual liquids, fold
down the bow handle (1) and
take off the motor head (
the bow handle with the locking
levers (14), hold the stainless steel
container (9) with one hand on the
bow handle and the other on the
54
bottom of the container and pour
out the residual liquid.
• Clean the waste tank with a damp
cloth.
• Wash the foam filter (
warm water and soap, and allow to
dry.
• Beat the dust out of the fluted filter
(
or hand brush.
• Replace the paper filter bag (
when full (see "Spare parts/Accesso-
ries" for reordering)
• Knock the optional dry filter (fabric
bag) out. Where necessary, wash with
lukewarm water and soap, and allow to
dry.
Maintenance
• The equipment is maintenance free.

Storage

1.
2.
3.
4.
3): fix
23) and clean it with a paint brush
Wind the mains lead (5) around
the handle (4).
Wind the suction hose (19)
around the handle (4).
The accessory holders (7/13)
are used to store the telescopic
suction pipe (17) and the nozz-
les (25/26).
Store the appliance in a dry
place and out of reach of chil-
dren.
21) with luke-
24)