Wet Vacuuming; Blow Function; Cleaning/Maintenance; Cleaning & Maintenance - Parkside PNTS 1400 E2 Originalbetriebsanleitung

GB
Vacuuming fine dust:
Specific suction processes (e.g. grinding
of paints and lacquers, milling or drilling
walls, grinding or drilling hard wood) can
pose a risk from hazardous dust.
We recommend using the following option-
al filter combination, which is available,
for fine dust (see "Spare parts/Accesso-
ries"):
1. Fluted filter (23).
2. Fine dust filter bag made of fleece
(optionally available see "Replacement
parts/Accessories"), which is used in
stead of the paper filter bag (24) in-
cluded in the scope of delivery.

Wet vacuuming

1. For wet vacuuming or to vacuum wa-
ter, fit the foam filter (21) to the filter
basket (27) on the motor head (3).
To avoid tearing the foam filter (21):
- Use only a dry filter;
- Before inserting, twist the edge of
the filter slightly and then roll it back.
2. Suctioning up (draining) water: place
the suction hose (
( 20) into the water tank and suc-
tion up the water.
3. Empty the stainless steel container
immediately after suction cleaning be-
cause it is not designed to store liquids
(see „Cleaning/Maintenance").
Never reach into the water to
be suctioned up. Danger of
electric shock.
10
19) on the handle
When the container (
suction opening is shut off by a float,
and suction is then cut off. Switch the
appliance off, remove the plug from
the socket and empty the container
(see "Cleaning/Maintenance").
If foam or liquid exits, switch off the
machine immediately.

Blow Function

Operation without the use of a filter
is recommended.
• Connect the suction hose (19) to the
connecting blower (15) on the motor
head (3).

Cleaning/Maintenance

Pull out the mains plug.
Danger of electric shock.
Always check the appliance before
use for any obvious faults such as
a defective mains cable, and have
these repaired or replaced.
Cleaning the device
Never hose the device down with
water. Never use aggressive clean-
ing agents or solvents. This could
damage the appliance.
• After use, empty the stainless steel con-
tainer ( 9):
- Opening the drain plug to allow the
vacuumed liquid to drain out (
10). A liquid residue remains in the
container.
9) is full, the