Overheating Protection; Cleaning And Care - Silvercrest STK 650 A2 Bedienungsanleitung

After the water has boiled, the appliance automati-
cally switches itself into the keep-warm function. The
control lamp 4 goes out, only the On/Off switch 8
continues to glow. As soon as the water cools, the
Tea Automat warms the water back up. The control
lamp 4 lights up again during this rewarming process.
Note:
As the water is fed back through the brewing system
during the rewarming, after the first brewing process
you should remove the brew system from the glass
pot 3.
Risk of personal injury!
The brew system is very hot! There is a risk of being
burnt! Use oven gloves when you take hold of the
brew system.
Note:
The longer the brew is kept warm, the greater is
the amount of fluid evaporated, and thus the brew
becomes stronger.
We therefore recommend that the tea be drunk as
soon as possible after brewing.
You can interrupt the brew process at any time:
For this, place the On/Off switch 8 back into the
position "0". The brew process is finished.
If you remove the glass pot 3 from the base 5,
the brew process is interrupted.
Attention:
Always first let the glass pot 3 cool down before
you pour in fresh cold water for another brewing
process! Otherwise, tension may be created in the
glass pot 3 and it could shatter.

Overheating protection

In the event of overheating, thermal protection switches
the heating element off inside the appliance. The
On/Off switch 8 remains lit, the appliance however
does not continue to heat up.
The thermal protection is activated if no or not enough
water is in the glass pot 3 and the appliance is
switched on anyway.
If the thermal protection function has switched the
heating element off, please proceed as follows:
• Allow the appliance to cool down.
• Press the Reset button 6 in the underside of
the glass pot 3.
The appliance can now be used again.

Cleaning and care

Risk of personal injury!
ALWAYS remove the plug before cleaning the ap-
pliance. There is a risk of electric shock! Allow the
appliance to cool down. Risk of Burns!
NEVER submerse the appliance in water or
other liquids! There is a risk of electric shock!
The appliance could also be irreparably
damaged!
To obtain an optimal result with every brew process
the appliance should be cleaned after every use.
This will avoid, that:
• The combination of scale and tannins, caused by
boiling the water and the tea brewing, impair
the function of the Tea Automat;
- 16 -