Putting Out Of Operation; Maintenance And Cleaning - Abicor Binzel PSB 31 Betriebsanleitung

7 Putting out of operation

7 Putting out of operation

8 Maintenance and cleaning

8.1 Cable assembly
8.2 Cutting torch
9 Troubleshooting
EN - 16
1 Switch off the cutting power source.
2 Close the compressed air valve.
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to for the entire duration of
maintenance, servicing, mounting, dismounting and repair work:
• Switch off the power source and close off the gas supply.
• Pull the mains plug.
1 Check screwings for tight fit and wearing parts for visible damage and
replace them, if necessary.
1 Check screwings for tight fit and wear parts for visible damage and replace
them, if necessary.
2 Clean the cutting torch body regularly to remove cutting spatter.
3 Ensure elastic function and proper fit of the fuse terminal. If required, clean
the contact faces of the fuse terminal and the torch contact pins to ensure a
reliable contact, and replace them, if necessary.
ABICOR BINZEL offers repair services at the factory.
DANGER
Risk of injury and machine damage when handled by
unauthorized persons
Incorrect repair work and changes of the product may lead to significant
injuries and machine damage. The product warranty will be rendered
invalid if the unit is handled by unauthorized persons.
• Operating, maintenance, cleaning and repair work may only be carried
out by qualified personnel (in Germany see TRBS 1203).
Please observe the attached document "Warranty". In the event of any doubts
and/or problems, please contact your retailer or the manufacturer.
PSB