Accessories - Abicor Binzel PSB 31 Betriebsanleitung

PSB
5.2 Manual cutting torch
5.3 AUT cutting torches
The torch head is positioned at an angle of 100° (PSB 31) or
105° (PSB 60/111), relative to the handle axis.
The wear parts plasma nozzle, protective cap, electrode and insulator are
parts that can be replaced simply by inserting them or screwing them in. For
protection of the operator, the torch is equipped with a fuse terminal, which,
upon disconnection of the wear parts, will automatically interrupt the switch-
on circuit.
Accessories such as torch carriage, torch circular guide and spacer can be
attached and locked on the outer contour of the protective cap.

Accessories

• Torch carriage for straight cuts or additionally equipped with circular
guide, prepared for cutting circular components in the range from ø100 to
ø1000 mm. (The torch carriage is clamped around the protective cap)
In these models, the cutting torch nozzles are positioned in a straight line,
relative to the torch body axis.
The wear parts plasma nozzle, protective cap, electrode and insulator are
parts that can be replaced simply by inserting them or screwing them in.
Accessories
• Mount for automatic cutting torch
5 Putting into operation
EN - 9