Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
11.2. Adjusting measurement force
•
Set the measurement force using the force setting knob (8), never change the force
setting during a measurement procedure (PRESET and workpiece measurements).
•
Enter the PRESET value (Chap 3.3) depending on the desired gauge ring, as
near as possible to the measurement to be made.
•
Adjusting the measurement using the gauge ring (see use), and recalling the
SET preset.
11.3. Use
•
Set the measurement height using the height measurement knob (1).
•
Release the measurement probes using the release lever (6).
•
Place the workpiece on the table
•
Release the measurement probes
•
Centre the workpiece using the centring lever (2), repeat the procedure until the
workpiece is correctly positioned.
Note
The table can be locked into a set position using the locking screws (5).
The axis return run may be limited using the optional stops (7).
23
E
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
