sylvac PS16 V2 Bedienungsanleitung Seite 19

9.1. Description
1. Quick release lever
2. Lever measurement
3. Measurement position adjustment knob
4. Positioning ring
5. Stop adjustable, high position
6. Stop adjustable, low position
7. Screws of the table (front and rear)
8. Spacer for thicker components
9. Location for dial gauge (plug)
9.2.Reference taking (--rEF--)
To place the axis at the end of its run and take the reference (--rEF--). --), the
measurement positioning ring must be released (release the screw). After taking
the reference, retighten the ring leaving 3mm between the measurement probes.
Fig. 1 Fig. 2
19
E