Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
9.3. Use
•
Lower the table and set up the depth stop using the knob (6) in order to let the
necessary gap to introduce the part to be measured
•
Place the part to be measured and set up the anvils opening with the knob (3).
•
Lift the table again with the knob (6) to the required position
E
•
Make the measurement using lever (2).
•
Use lever (1) for quick release of the table. Once setting is done, use only the
quick release lever (1) to measure the next parts.
9.4. Specifications
Type
Dimension table
Release
Measuring range
Measurement capability
Remark
The table may touch the anvils in the up position and damage them.
9.5. Options
Table can be adjusted in a lower position in order to measure thicker components. A
set of spacers (8) is delivered with the table. A dial indicator (9) with special contact
point can be mounted on the table.
25
58x70
7mm
3mm
25mm
20
50
92x70
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
